several model railroaders have asked how the sleeping-car type of P/AB30 LSModels or RailTop can be opened to the position for night beds installed. In consequence, a detailed manual, step by step: (pull out just down)
- off trucks.
- car body in both hands take with regard to the car floor, entrance end facing up.
- your thumbs on the car body such as in the amount of the trunnion and spread with the finger as the car floor to the steps below to remove. Caution: Never touch the car body not to the molded eyelets or other fragile details. Spread
- the level of the battery cases the car body and pull out the battery boxes on the floor.
- preparatory work in this instance to the other end and eventually the car body off.
- sit To expand (which is only in the two adjoining sitting necessary, the third remains in the compartment), go with a tool (eg screwdriver) under the front edge and pry the seat up.
- install beds so that the pillow facing the side passage. For single occupancy is only the lower beds available. The first and last compartment can be represented only as a position for days or single.
- Body Place right side up (initial step at the end).
- bogies installed right side up (clutch recess to end, dare line simulation, the output side).
The original version is the sleeper car with 20 compartments to be opened in the same way.
0 comments:
Post a Comment